• The Air Intake Heater (AIH) found in ’99.5 and up 7.3 Powerstroke (Not for F650/F750) blocks approximately 20% of the airflow through the intake manifold.
• The eliminator plug allows for increased airflow and better combustion.
• The plug has the correct thread type, and length.
• The Boost Gauge Plug for Boost Gauge is drilled, tapped, and installed.
• It also includes the Boost gauge fitting to allow you to connect your boost gauge to the Air Intake Horn with 1/8" line.
• Easy Installation.
• Add the AIH Code Eliminator below when removed to avoid any Engine Codes on your PCM
• Instruction available from the Documentation link in our main menu.

$29.00

$25.00

$12.00

• Code P0541 is detected and logged during a diagnostics scan of specific sensors by the PCM at start, when the Air Intake Heater plug is disconnected.
• The harness, used in conjunction with the AIH plug will stop the PCM from throwing the dreaded P0541 code "Intake Air Heater Relay 1 Low ".
• Easy to install.
• Use it when you remove the AIH.
• Built for exact fit.
• Free Shipping (Lower 48 States)!

$19.00

• SCT XCAL 3 Programmer, w/Custom Tunes. Adds up to 150 Horse Power, 290 ft-lbs torque!
• Fits all 99-Up 7.3L and 6.0L Powerstroke Turbo Diesel Engines (F-250, F-350).
• MagnaFlow Stainless T-409 Turbo Back System.
• AFE Stage I Cold Air Intake System.
• 3-Gauge Painted Pillar with Boost, Trans, and EGT Autometer Gauges.
  
• Fully Painted, Pre-assembled and wired (Ultralite, Z-Series, Phantom, or Sport-Comp)
• Free Shipping in the Lower 48 States!
• Choose your paint option HERE.

Now $1,299.99